want more power

Discussion in 'Modifications & DIY how-to' started by 03scooby03, Apr 18, 2007.

  1. 03scooby03

    03scooby03 Member

    im fairly new to the subaru scene need a little help. i have a 03 wrx i have already installed a full turbo back 3in. exaust, intake, need some more suggestions for fairly enexspensive mods????
     
  2. Weapon

    Weapon 90lbs of dynamite Supporting Member

    catless uppipe, bigger topmount, engine management for power. Have you considered any suspension mods (springs, struts, swaybars)? getting stiffer motor mounts, pitch mount and tranny mount make a noticable difference. steering rack bushings and shifter bushings are a nice touch with a short shifter. remember there are a lot of mods that make the car perform better besides power.
     
  3. keeganxt

    keeganxt Active Member

    yeah with all this ^^^. That's about it until you get a bigger turbo, which you would need bigger injectors and fuel pump to run. But EM or a reflash tuner will give you a huge increase if you haven't done so already. And to truely unlock what you already have you gotta get a tune.
     
  4. heathbar

    heathbar Member

    yeah, i'd recommend uppipe and EM w/ a protune if you can.

    Also, if you're gonna do any mountain runs or autoX, you'll notice the stock brakes and suspension just won't do. :hsnono:
     
  5. Strayen

    Strayen Active Member

    Get an Uppipe for the least expensive mod to help you out the most. The install is a PITA though.
     
  6. heathbar

    heathbar Member

    true... Although, I thought the UNinstall was the worst part.
     
  7. sleeper31204

    sleeper31204 Member

    Yeah, when I did my exhaust kit. Or not even that, when I took my uppipe out for some work to be done on it, I still had to take out the down pipe just to get to the bolts on the uppipe. But it is a good move for less than 200 bucks, which will help out a lot when you tune the car with some sort of engine management.
     
  8. WJM

    WJM Banned

    Buy an STi....05 or 06.
     
  9. 03scooby03

    03scooby03 Member

    cool thanks for the help. i have replaced up pipe now. what are the restrictions as far as boost? i recently purchased a gready profec b spec 2 boost controller. running about 16-17 psi. is this safe? i have not thrown any check engine codes, runs fine but what are the long term effects?
     
  10. 03scooby03

    03scooby03 Member

    ^^^^ also getting a tune in 2 weeks?
     
  11. Weapon

    Weapon 90lbs of dynamite Supporting Member

    be careful running a boost controller without engine management. 16-17 psi should be ok. Actually with Engine management you dont even need a boost controller. are you getting accessport or ecutek?
     
  12. mokinbird87

    mokinbird87 Active Member

    we couldnt change the psi on the AP right? i got the version 1. what do you mean we dont need a boost controller?
     
  13. Weapon

    Weapon 90lbs of dynamite Supporting Member

    correct me if i am wrong but if you get tuned by SS you can adjust boost for both accessport and ecutek? you can adjust it yourself with street tuner yes?
     

Share This Page