Dented Down pipe... problem? help (tune question)

Discussion in 'Modifications & DIY how-to' started by 19-Kilo, Dec 2, 2008.

  1. 19-Kilo

    19-Kilo Member

    I had to drive on a gravel road today as part of work... and unfortunately I ran over a big rock. :unamused:

    The rock has put a big dent in my Turbo XS 4" down pipe. The dent is about an inch deep and about two inches long and is at the neck of the down pipe just before it meets up with the cat (the lowest part, go figure).
    I am pissed... but that is irrelevant. :eek:

    I am running a 20G with a large TMIC and a Protune (thanks Scott :bowdown: )

    Will this crushed/dented down pipe hurt my car by affecting the tune?
    Do I need to get this fixed? or just run with it knowing that I have some more restriction due to the crushed down pipe.
     
  2. slowwrx

    slowwrx Supporting Member

    most likely no its probably not hurting anything.
     
  3. Kokopelli

    Kokopelli Active Member

    I would check the flange where it bolts to the turbo. Mine had a crack in it that I figure I got bottoming out on a speed bump.

    Didn't affect performance but it did cause a little extra noise.
     
  4. Trancetto

    Trancetto Active Member

    :eek:hnoes::eek:hnoes::eek:hnoes::eek:hnoes::eek:hnoes::bowdown::bowdown::bowdown::bowdown:
     
  5. 19-Kilo

    19-Kilo Member

    any other informed opinions?
     
  6. blindfold

    blindfold Active Member

    you should be fine, are you lowered at all, running the same downpipe here
     
  7. Doug@DBW Motorsports

    Doug@DBW Motorsports Active Member

    You should be fine.
     
  8. 19-Kilo

    19-Kilo Member

    yea, running RCE yellows. about 1inch lower.
     
  9. blindfold

    blindfold Active Member

    maybe it is time to switch to Swift R-specs
     

Share This Page