Defi egt going haywire...

Discussion in 'Modifications & DIY how-to' started by WRboXer, Mar 10, 2011.

  1. WRboXer

    WRboXer Active Member

    My defi egt recently has been acting up on me. Sometimes it reads normal, then it will slowly sweep and then peg the gauge, then will all together go to zero and will not respond to the control unit inputs. What do I need to fix/replace?
     
    WRboXer, Mar 10, 2011
    #1
  2. integroid

    integroid Supporting Member

    Sounds like amybe the sensor. You could probably check it with a multimeter. Have you tried to contact Defi support?
     
    integroid, Mar 10, 2011
    #2
  3. Alex

    Alex Community Founder Staff Member

    Its either the sensor or a grounding issue I would think.
     
    Alex, Mar 10, 2011
    #3
  4. pEd

    pEd This ain't no Piccadilly!

    Yeah,

    Grounding issue would be my first guess.
    Then I'd check the sensor.
     
    pEd, Mar 10, 2011
    #4
  5. Cool_____

    Cool_____ Banned

    your motor is about to explode. Danger to manifold!
     
    Cool_____, Mar 10, 2011
    #5
  6. Alex

    Alex Community Founder Staff Member

    The floor pan has got to fall out first ;)
     
    Alex, Mar 10, 2011
    #6
  7. WRboXer

    WRboXer Active Member

    Fuck the laptop... "slam"
     
    WRboXer, Mar 10, 2011
    #7
  8. Cool_____

    Cool_____ Banned

    In all honesty I see two issues.....ground bad or the sender is bad.
     
    Cool_____, Mar 10, 2011
    #8

Share This Page