Help me swap transmission in WRX

Discussion in 'Meetups & Events' started by UpSideDownDesi, Nov 18, 2011.

  1. UpSideDownDesi

    UpSideDownDesi Active Member

    Well I can use a helping hand from my fellow WRXAtlantians with helping me swap transmission and rear diff in my WRX. I have all the tool, just have never done subaru trans before. Will be great to have someone who has done one already.

    I am planning to start Sunday afternoon. Beer, drinks, pizza & grilled (tandoori chicken) will be fired up to take care of the hunger part. I will happily compensate gas if you like me to.

    Please let me know if you can help. :D
     
  2. Sparta

    Sparta Active Member

    Don't u have a 6 speed?!
     
  3. UpSideDownDesi

    UpSideDownDesi Active Member

    Swapping in a 07 sti 6spd. Longer gear ratios FTW
     
  4. crash#2

    crash#2 Member

    it's easy. but if you don't have a tranny jack you'll need two robust young men to help you line it up and some long peices of wood on top of a jack.
    i've pulled my tranny with just one helper. it's easy. just look up a clutch install on nastysoc
     
  5. Alex

    Alex Community Founder Staff Member

    I have a tranny jack if you need to borrow one. I'm not sure I'll have a chance to hang out and assist however :(
     
  6. UpSideDownDesi

    UpSideDownDesi Active Member

    This will be happening on jack stands so should be fun. I am borrowing transmission jack from alex so that should help a little.

    Alex, that will help bunch. I can swing by and pick that up today. Please PM number & address and what time I can pick it up :).
     
    Last edited: Nov 19, 2011
  7. kohlby777

    kohlby777 Member

    I dont have any experience doing it myself, but I'll gladly help out anyway I can man. I'm getting ready to do a swap sometime in the near future too
     
  8. AutoxSTi

    AutoxSTi Member

    Can the trans be removed with just jack stands? Wasn't sure if they were high enough. Unless you have access to a lift.
     
  9. Jake

    Jake Active Member

    done it a couple of times. may have to put blocks on the stands and raise them up a good bit. but its been comfortable enough to get two people underneath and the transmission. well comfortable is relative, haha
     
  10. AutoxSTi

    AutoxSTi Member

    Hmmm, I've got a couple of jacks and jackstands that can go up to 18 inch high. Would that be close in getting that trans out? Might as well pay someone to just remove and rebuild it.
     
  11. UpSideDownDesi

    UpSideDownDesi Active Member

    I am gonna get few block just in case we need to raise it few more inches if needed. I am going to make sure this puppy ain't moving a inch before i get under and get busy.
     
  12. Jake

    Jake Active Member

    i think both times ive removed a tranny, we pulled the engine first. gives you a ton more room, and you have to unbolt it anyways
     
  13. liltoua

    liltoua Member

    hmmm what else would I need if I want to swap your old 6 speed into mines (^_^)
     
  14. Cool_____

    Cool_____ Banned

    I've done my 6 speed all by my lonesome....boy was that not fun. That thing is one heavy thing....makes the 5 speed feel like a loaf of bread.
     
  15. AutoxSTi

    AutoxSTi Member

    How bout rebuilding one? Pain in the neck as well?
     
  16. Cool_____

    Cool_____ Banned

    You shouldn't try that yourself. Andy@KillShot is your guy for that ;)
     
  17. AutoxSTi

    AutoxSTi Member


    LOL! was just asking. It's not like my Honda Civic...hehehehhe!
     
  18. Cool_____

    Cool_____ Banned

    Indeed.....Subaru transmissions have to be done dead one and perfectly right. There is absolutely no room for error like there is on a Honduh.
     
  19. AutoxSTi

    AutoxSTi Member

    Fair enough. Will let Andy Git-R-Done! :)
     

Share This Page