Search Results

Search Again
  1. ruff1
    Post

    Release - Throwout Bearing removal ???

    Did'nt want to bug you. :o should have...
    Post by: ruff1, May 13, 2008 in forum: Modifications & DIY how-to
  2. ruff1
    Post

    Release - Throwout Bearing removal ???

    Sorry for the post... Found the answer on Nasioc...Remove Clutch fork allen nut, thread a small bolt (7mm I think into the hole), pull out the...
    Post by: ruff1, May 10, 2008 in forum: Modifications & DIY how-to
  3. ruff1
    Thread

    Release - Throwout Bearing removal ???

    Guys I'm stumped on how to get the Release bearing out of the trans. I have an 02 Turbo 5MT. I've removed the access plug (allen nut) from the...
    Thread by: ruff1, May 10, 2008, 3 replies, in forum: Modifications & DIY how-to
  4. ruff1
    Post

    Flywheel Resurfacing (Where and $$)

    :hsnono: Right ...never again. P.S. the Clutch place in ATL was closed so I went to Clutch Exchange Service in Conyers. Was in and out in 15...
    Post by: ruff1, May 10, 2008 in forum: Modifications & DIY how-to
  5. ruff1
    Post

    Flywheel Resurfacing (Where and $$)

    Hello and thanks Mike, Finally got the WRX 5MT out of the SVX last night and sure enough the Mother in Law wore it out all the way. She won't...
    Post by: ruff1, May 10, 2008 in forum: Modifications & DIY how-to
Showing results 1 to 5 of 5
Search Again