Clunking noise

Discussion in 'Modifications & DIY how-to' started by sobe_death, Jul 1, 2010.

  1. sobe_death

    sobe_death New Member

    Joined:
    Feb 28, 2010
    Messages:
    22
    Likes Received:
    0
    Ok, I know the title was pretty general, but I'm having a hard time tracking down a noise in the legacys suspension.

    I get a clunking over rough pavement, but no noise if I'm traveling over speed bumps. This should point to sway bar end links, correct?
     
  2. sobe_death

    sobe_death New Member

    Joined:
    Feb 28, 2010
    Messages:
    22
    Likes Received:
    0
    Thanks. The strut tops are good; I think they may have even been replaced in the past 10 years sometime. I guess it's down to the sway bushings and end links. It only seems to do it over uneven pavement at low speeds, and I would expect the strut tops to make noise on any bump.
     
  3. Alex

    Alex Community Founder
    Staff Member

    Joined:
    Oct 7, 2003
    Messages:
    15,892
    Likes Received:
    20
    So for clarification's sake, the noise only occurs when one wheel is at a different height than the other, but not at the same time (as in a speed bump)? How are your endlinks looking?
     
  4. sobe_death

    sobe_death New Member

    Joined:
    Feb 28, 2010
    Messages:
    22
    Likes Received:
    0
    Correct. I gave them a look the other day when I had the car on the lift and didn't see anything amiss other than slightly worn endlink bushings. They didn't make noise when I pulled on them and didn't look so damaged as to clunk either, though looks can be deceiving.
     
  5. Alex

    Alex Community Founder
    Staff Member

    Joined:
    Oct 7, 2003
    Messages:
    15,892
    Likes Received:
    20
    Did you check the torque?
     
  6. SubiNoobi

    Supporting Member

    Joined:
    Feb 5, 2006
    Messages:
    831
    Likes Received:
    0
    Endlinks can make noise if they are loose, but they can also bind and "pop" when they are over-torqued.

    Do you have stock or aftermarket links?
     
  7. sobe_death

    sobe_death New Member

    Joined:
    Feb 28, 2010
    Messages:
    22
    Likes Received:
    0
    Everything is stock, though I haven't checked torque on them (they are tool tight)
     
  8. RSConvert

    RSConvert ɹǝuɹnʇpɐǝɥ uʞnɟɐɥnɯ ɐ sʇı
    Supporting Member

    Joined:
    Oct 5, 2007
    Messages:
    719
    Likes Received:
    0
    Have you found the issue?
    IMO it sounds more like a tophat issue. I would remove the bottom bolts from the endlinks and roll around, listening if you still get a "clunk".
     
    #8 RSConvert, Aug 7, 2010
    Last edited: Aug 7, 2010

Share This Page