Shit!!

Discussion in 'Modifications & DIY how-to' started by Dheim96, Dec 26, 2011.

Page 2 of 2
  1. Dheim96

    Dheim96 Member

    Joined:
    Sep 7, 2010
    Messages:
    380
    Likes Received:
    0
    lol
     
    #51 Dheim96, Jan 3, 2012
  2. CelticPride

    CelticPride Banned

    Joined:
    Dec 1, 2011
    Messages:
    761
    Likes Received:
    0
    Well it's obvious your CV was leaking so there's your fluid loss.

    But what's this?
    [​IMG]
     
    #52 CelticPride, Jan 3, 2012
  3. WRboXer

    WRboXer Active Member

    Joined:
    Jul 23, 2004
    Messages:
    584
    Likes Received:
    0
    itll buff out
     
    #53 WRboXer, Jan 3, 2012
  4. CelticPride

    CelticPride Banned

    Joined:
    Dec 1, 2011
    Messages:
    761
    Likes Received:
    0
    Also noticed what looks like a weld mark on the plug....never noticed that before. Have you had trans work before (be it a fluid change or anything other than a clutch job)?

    Nevermind I went back and read where you said it was missing bolts and looks like prior work before you bought it.

    This sucks dude.
     
    #54 CelticPride, Jan 3, 2012
  5. Alex

    Alex Community Founder
    Staff Member

    Joined:
    Oct 7, 2003
    Messages:
    15,892
    Likes Received:
    20
    Was the verdict to repair/replace or to migrate to a 6 speed?
     
    #55 Alex, Jan 3, 2012
  6. Dheim96

    Dheim96 Member

    Joined:
    Sep 7, 2010
    Messages:
    380
    Likes Received:
    0
    It was to replace it. I was able to get a transmission from andrewtech. The time to get a good 6 speed and install it would have taken to long, so it wasn't an option at this point.
     
    #56 Dheim96, Jan 3, 2012
  7. Dheim96

    Dheim96 Member

    Joined:
    Sep 7, 2010
    Messages:
    380
    Likes Received:
    0
    Its being put in right now and should be ready to go by the end of the day. I'm back in GA right now so I'll have to drive up on sat to pick it up.
     
    #57 Dheim96, Jan 3, 2012
  8. BKiller

    BKiller Active Member

    Joined:
    May 30, 2007
    Messages:
    862
    Likes Received:
    0
    I like this custom cotter pin on the lower ball joint!

    [​IMG]
     
    #58 BKiller, Jan 3, 2012
  9. Jake

    Jake Active Member

    Joined:
    Jul 8, 2006
    Messages:
    3,845
    Likes Received:
    0
    looks like shrimp....

    and yeah i was pretty much in the same situation when my tranny went, but i regretted not being more patient and finding a good 6speed
     
    #59 Jake, Jan 3, 2012
  10. CelticPride

    CelticPride Banned

    Joined:
    Dec 1, 2011
    Messages:
    761
    Likes Received:
    0
    So you picking the car up this weekend?
     
    #60 CelticPride, Jan 6, 2012
  11. Dheim96

    Dheim96 Member

    Joined:
    Sep 7, 2010
    Messages:
    380
    Likes Received:
    0
    I am leaving tomorrow morning to get it. They also found a hole in the wastegate signal line so they replaced it. Hopefully the car will feel stronger now that it was replaced.
     
    #61 Dheim96, Jan 6, 2012
  12. Matt

    Matt Think before you post
    Staff Member Supporting Member

    Joined:
    Oct 8, 2003
    Messages:
    8,409
    Likes Received:
    23
    Good luck dude!
     
    #62 Matt, Jan 6, 2012
  13. CelticPride

    CelticPride Banned

    Joined:
    Dec 1, 2011
    Messages:
    761
    Likes Received:
    0
    Yeah good luck man!
     
    #63 CelticPride, Jan 6, 2012
(You must log in or sign up to post here.)
Page 2 of 2

Share This Page