Silver Dollar Raceway

Discussion in 'General Community' started by AK_Raptor, Feb 10, 2008.

  1. AK_Raptor

    AK_Raptor Member

    Was up at the drag strip today and ran into LiquidForce

    my best run was 13.648 @ 100.01
     
  2. bjtyson3

    bjtyson3 Member

    i went there last saturday and ran 13.1 at 106...was hopin for mid/low 12's..but almost everyone i know that was there that day were running almost a second slower than usual
     
  3. scoobaru

    scoobaru Active Member

    not bad, what were you 60 ft times? what did mike run?
     
  4. Kokopelli

    Kokopelli Active Member

    I had my personal worst 16.338 @ 72.89. I still beat the civic next to me. He ran a 19.99 @ 62.


    My best was 13.36@ 115.73 and that was running 11lbs in first and second and running progressively more boost in each gear until I hit 28 pounds in 5th. The clutch would hold fine when I did this but if I launched it I pretty much just sat still. The run would have been a little better had I not missed third.

    But I made up for missing third by hitting third twice on the next run. 1 to 2 to 3 to 4 and back to 3 instead of 5. According to the avcr I hit 8590 rpms.



    I guess its time for a new clutch.
     
  5. techlord

    techlord Active Member

    so much for that kevlar repadding. what do you think will be next? What can hold that kind of power?
     
  6. cleanmachine

    cleanmachine Member

    Those times are around the time I ran. I only ran my car once at Commerce and ran a 13.6 @ 99mph. My best 0-60 time was 5.2.
     
  7. Does one normally use fifth gear at a dragstrip?I did not realize that our cars were geared that way.I used to drag my mustang and it would just about pull 100 in third.
     
  8. ShaneSTI

    ShaneSTI Active Member

    next weekend..i will be there. i know their are a few cobras that show up, but would be nice to see the subies.
     
  9. Kokopelli

    Kokopelli Active Member


    I have a jdm six speed. 5th in mine tops out at 126. 4th is around 92.
     
  10. AK_Raptor

    AK_Raptor Member

    60' 2.053 and I would be putting it in 5th right at the end
     
  11. Kokopelli

    Kokopelli Active Member


    I am going back to a ceramic 6 puck. The flywheel and pressure plate should be in decent shape since the kevlar is not as rough on them as ceramic. Getting the clutch plate re-pucked should be less than 100. Its just the time to do it that sucks.
     
  12. bjtyson3

    bjtyson3 Member

    5th at the end for me too..1.9 sixty feet..usually putt 1.7's
     

Share This Page