access port issue

Discussion in 'General Community' started by redman, Feb 20, 2008.

  1. redman

    redman Member

    Hey everybody, sorry to inconvenience anyone but I have a small request. I just bought an access port 2.0 from GNV Motorsports and when I tried to install it, it would not sync up with my car. When I called Cobb, they said it is the connector that plugs into the OBD II port that was causing the problem. Is there anyone on here that is somewhat close to stockbridge that would meet up with me and let me borrow their OBD II connector for a few minutes so i can flash my ECU? I would greatly appreciate it.
     
    Last edited: Feb 20, 2008
    redman, Feb 20, 2008
    #1
  2. keeganxt

    keeganxt Active Member

    are you referring to the AP-->Car cable? or something else?
     
    keeganxt, Feb 20, 2008
    #2
  3. redman

    redman Member

    the plug that goes into the OBD II port, the piece that the small end of the USB cable goes into.
     
    redman, Feb 20, 2008
    #3
  4. BKiller

    BKiller Active Member

    I'm over in McDonough and would let you borrow mine.
    PM me and we can meet up.

    Brandon
     
    BKiller, Feb 20, 2008
    #4
  5. Matt

    Matt Think before you post Staff Member Supporting Member

    can't you return it to the shop/dealer for a replacement? Since they sold you a defective device, I would assume they would step up to the plate and make it right.

    ??
     
    Matt, Feb 20, 2008
    #5
  6. redman

    redman Member

    I sent them an email tonight about it. I just wanted to make sure that was what it was and go ahead and get it flashed if I could.
     
    redman, Feb 20, 2008
    #6
  7. BKiller

    BKiller Active Member

    Well, how's Stage1 treating you?
     
    BKiller, Feb 23, 2008
    #7
  8. redman

    redman Member

    very well, i love it. so much more fun. thanks again man.
     
    redman, Feb 23, 2008
    #8

Share This Page