Guys I'm stumped on how to get the Release bearing out of the trans. I have an 02 Turbo 5MT. I've removed the access plug (allen nut) from the side, where the Fork pin goes...Do I drive the pin out or unscrew it or what. I can't push the fork back far enough to get it to disigage the bearing tabs. Totally stumped and I don't want to screw anything up. Thanks in advance...Marc
Sorry for the post... Found the answer on Nasioc...Remove Clutch fork allen nut, thread a small bolt (7mm I think into the hole), pull out the fork Pin. then you can pull the fork up and get the bearing off the shaft...DUH .. P.S. I removed the tranny the hard way!