Help: Goes before she blows

Might have a boost leak in the vaccum lines that go from Your turbo housing to the waste gate, Any one agree? Moose,Milo?

 

:dunno

 

See i have had that happen. I had a small hole in one of the two lines and my car was over boosting. Won't hurt to check it out UBAR.

 

Yeah, check that out first.

Also, short ram and AP Stage 2? Cobb strongly recommends against doing that.

 

Could this be boost creep from the wastegate not actuating properly? What type of dp do you have? I've heard the divorced wastegate pipes are better for preventing creep.

 

yah those vaccum lines if there is a small hole you will get boost creep.

 

mine is doing the same thing, started last week when I put my hyperflow tmic on. Not sure what's going on. It mainly does it in 4th and 5th, it will hit the lamco emblem.

 

can be very small, take the hose and bend it to see if there is any cracks or holes, by bending it it should stretch out the hole or crack if there is any.

And goose, Is the TMIC hitting those lines as we'll because if so it may have cut a hole in it also.

 

from what i hear divorced wastegate DPs are usually worse as far as creeping issues go.

 

I'll check it out, thanks. It's kind of scary; so I'm trying not to let it over boost too much.

 

mine has spiked to 17.7psi after the hyperflow... i would expect a slight increase in boost due to the lower pressure drop

 

best bet it's the vac lines i aint a expert like others but in my thinking it should have a good amount of leak to have a over boosting

 

Milo, shouldn't the ECU acct. for this and retard boost though?

 

the adaptive ECU can only do so much... if it didn't adapt, the boost would probably be much higher

 

kinda strange because .15 mpa is 21.75 psi not 18.3 psi..is something wrong with your AP?

 

I'd trust the AP readings over the stock gauge.

 

I thought about that after i posted it. it wouldnt surprise me if it was the stock gauge..it sucks

 

18.3 with stage 2? i believe that its only supposed to run 16.5+/- on stage 2 unless you're pro-tuned.
short ram='s bad juju with AP OTS

 

no I believe the AP boost tune once reflashed with it if i'm not mistaken it should be 15.8 and rev limit pushed to 7200rpm's.

 

PROBLEM DIAGNOSED!
my top mount crushed one of the lines that t off to the actuator. I tried to repair it with my trusty electrical tape but only caused another tear....woops. Oh well, good excuse to buy some silicon lines now

 

Told ya goose! was I right or what ! we'll I,m glad you found it. You can bye the vaccum lines ata ny autopart store.:sx:

 

yep, I actually found another thread on nasioc about the same thing, everyone said what you said...Check the vacuum lines!

 

Coll Beans man! Glad to hear you found the prob.