Just for fun. Was bored today, have been wanting a weighted shift knob for a while now. Didnt want to spend the coin, have a polymer knob i dont care about. And i wanted a shifter extender for teh track day. So i wanted to share my creativity(or lack of). Knob + spade bit. Washers + bolt + 5 min epoxy Put assembly in knob and cover with putty epoxy Sand it to little for the custom look() and then bling it hard with BBS gold paint Make shifter extension. Box rod steel plus a 12x1.25 thread bold with the head cut. (Grind the sides of the bolt to make more square, torch box rod, hammer in...profit) Assemble(note, flux coring of nut on bottom of assembly not pictured) STOCK PIMPPPPPPPPPPPPPP!!(electrical taped the rod and rest of the assembly for baller status)
Ha Ha Nice work man! Is that truly BBS Gold or the Grimm Speed Gold...If its BBS then I need you hook up on paint!