I've got some snowflakes [IMG]
https://atlanta.craigslist.org/nat/bik/5633722680.html it's local east cobb and within your budget @$750, sorry I thought I included a link
[IMG] full suspension and will fit in the leaf
maybe start at a bike shop?
Phase II EJ205 series engines will be 52mm bearings with the thrust bearing in the #5 location. To find size can be tricky... and best to leave...
steel lugs or steel seats on lightweight lugs will distort the mating surface on Aluminum rims if ran loose or overtightened so you might want to...
Pads stainless lines and fluid are a good start
While the PW bling is worthy of the comments, funny that not one comment about the ELECTRIC power steering pump
[IMG] Amazon?
oil filter adapter with a built in thermostat?
if that's the case you now have hot spots on the flywheel and glazed up clutch. While driveable it may not be ideal, only time will tell. If the...
sounds like a missed shift lunched your clutch... well maybe the T/O bearing and/or the fingers on the pressure plate, or you put a nice divot on...
nothing wrong with a JDM motor. If the long block is NON avcs then all you'll need to do is swap your old crank and cam sprockets along with the...
check with your insurance, I've had chips repaired at no cost
save yourself some money and take it now, Brandon and King will do it right
[IMG]
with a 13 yo car and you can be never too certain what has been done in the past, I'd take it by a supporting vendor and have it logged to to make...
Dia and thread pitch should be the same
[IMG] [IMG]
I have the needed pliers to do the job but there is NO possible way to do it without removing everything off the top. Do not use the typical worm...
Separate names with a comma.