i am most curious about this.. it implies a tranny that holds like a 6 speed for less than 3k? down the road i had basically decided if i go up a...
went by there. apparently a number of folks have left ts for forged and forged will be doing subies. which is great for me since they are very...
they ah.. do subies??? and if so what engine management.. parts availability etc.. etc..
i had a similar setup on a crx which was my toy car for a while and i loved what it did to that car. gc+koni is a good setup in my opinion. there...
2003 stock WRX (till now) I ordered the following and installed it myself: ground control complete units, single adjustable, ground control...
welp.. no one answered.. i went and bought em from oakus. we'll see how they turn out.. also went and bought some ground control camber...
a guess.. you might be the only builder putting the block together, putting both plates on and then boring/honing. this cannot be a bad...
posted this on Nasioc but i figured id see if i could get some info here.. 2003 wrx, stock to this point, im rebuilding the suspension, GC...
i actually used these guys maybe 15 years ago. they had good rep then. think i bought panasports and had some soft compound tires mounted on a...
and you are where exactly.. and are you the 'jeff' in below? if you are at SOK then that makes things simple for me.
about half way through my suspension rebuild: 2003 wrx up to now un-modified. a DD, will not be tracked. goal is to install suspension stuff...
what about APS? compared to cobb.. and what about their 3.5 inch TBE? And its a bit confusing with APS because you can order a high flow cat at...
where do you get the coupon?
the one big problem bushing is the front trailing arm bushing. is metal ringed with rubber and supposedly often takes a full 20 tons of force to...
I have a 2003 WRX sedan. after 6 years or so i am finally getting around to upgrading some of the parts.. so i start with the suspension.....
i know the stock ECU wont do this.. but i wonder if one of the stand-alones or piggy backs can....
so i go to that website and it says you need a flex-fuel controller.. now what i'd like to know.. is it possible to convert wrx/sti to flex...
a guess. difficult to determine what the difference is except perhaps with the longevity of the rings and maybe how quickly they break in. what...
would be interesting to hear why some think its required and some not. If you check the video (costa mesa engineering . fixed url) you will see...
i'd like to know too. not knowing any better, i would want a torque plate used when the bores are sized and honed.. and do that put the block...
Separate names with a comma.