and they're square cut too!!! Totally worth the price
Well I'll be, didn't know they were serviceable from the dealer, found the part number 33.32 MSRP This is the kit I remember being so pricey...
I can't think of why any of that would happen. Its a pull type clutch, so if the TO bearing wasn't engaged you'd have no resistance and the pedal...
Yeah only source I know of it the UK guy and for what they cost, he might as well buy a reman one and just do the exchange.
What slave cylinder? Same setup on my car just a 2.5 block I am not sure if the rod length is different between the slave cylinders Are you...
Yeah my centric kits were $5 each, I have the wrappers somewhere if you need the part numbers. If the piston is rusty I doubt it will be too...
Look for 4032 pistons. They are harder, more brittle than 2618 forgings but still mush stronger than stock. You can run tighter PWC clearance...
Brakes will work with water in the lines it just compresses more than brake fluid. Sounds like your best bet is to just buy a rebuild one and...
They sell shortblocks preassembled. I don't know the part number as it has changed over the years. Even a new motor is prone to ringland failure....
If you truly want to go stock for stock. I have bought parts from subaruparts.com and subarupartswarehouse.com Subaruparts' prices have gone up...
Some place in the UK sells a rebuild kit with new pistons. The seals can go bad but the pistons shouldn't rust unless you get water in the lines....
eww have you found anyone that can run a strainer? an inline will be fine but if the pump sucks in trash you risk damaging it or marring it's...
I helped pull a head off a motor today that had a screw smashed between the piston and head... dropped during a tgv install. Could be worse. A...
I just went off this. FPR rises with boost pressure. I don't know your whole fuel system aside from problems before the rotato and after the build.
its not a vacuum problem?
Did you leave the vbands on the downpipe loose to see if you could get the fitment any better. Coolant sounds fine, it'd only need two caps...
A dude out this way did the same thing. Truck -> Camry -> pair of bugeyes -> CTS-V I looked at the older ones but they were too small for...
IDK yours has 2 solenoids and not that vacuum one, I'm sure it will trip some code. I gave this some thought because I will have to do it. I...
Those are fuel system evap solenoids, they can be deleted, but it requires a little more than just unplugging them. I leave them alone on mine.
Yeah it should work, it may be too big as those were intended to go on the large bung of the coolant aerator tank and the back of the head. You...
Separate names with a comma.