How are you breaking it in? Some start and idle it for like 15 minutes and then drain the oil and then go about driving it like normal. Some hold...
yup did a clutch last night. I hate bolting the bell housing to the engine.
I guess I did have more issues... lots of blow by pressurizing the crank case. Not enough to blow out seals but still leak from there.
I vote all of the above down as that is where mine was leaking from. I'd still try to get it out. drill it some more heat it, use an extractor......
Yeah with those MAW tgv deletes no gaskets are used just the orings they provide
pull the tensioner pin and then use the diagram in the FSM to count teeth on the timing belt to make sure everything is in time. should be like...
whew got the cross over on and doesn't look like anything stripped. Your going to have to pull that bottom passenger's side idler pulley off to...
I feel ya there. I currently have 2 maps to work with for my car... granted I don't know how to work with them. My current tune is for the vf39...
Where and why? for the front center cover? I've never had problems with those, but I did buy new rear side covers because they heat softens that...
don't rush is key so you don't forget something and have to go back and redo it. Get the heads on ASAP so you can torque them and let them sit a...
I'm out in Augusta. We make it out Atlanta every so often seeing as there is so much to do here (sarcasm). I'm going through the same thing as...
KStech make cheap tgv block off plugs we used on a build. Removed the servo's, cut out the butterflies and rod, the port work was mostly just...
Hopefully just new bearings and possibly 100mm pistons though. I know for me it will just be pistons and case halves. I unfortunately have...
Your pedal would most likely stick to the floor if it was anything hydraulic. Throwout bearing sounds right if the clutch isn't operating. Or...
Well I just ran my numbers by ACT and might need to upgrade my clutch for my power. I don't know if you'd be interested in a used clutch but its...
My ACT has an exedy disc, stamped right on the center section. I'm sure the pressure plate is ACT and that's what does the clamping, where the...
You can't buy common sense though... sorry, long day of dealing with idiots
Valvetrain down (getting sprayed) ports only see gasses and fuel (or should only see that) So they don't accumulate much. The carb cleaner would...
Just use water. Some cleaners are caustic to the aluminum. PP might be one of them as I know castrol super clean was/ is Obviously get as much...
So you are running 99.75's You can strip the head down to just the valves, springs, and retainers and run it through the dishwasher on a hot...
Separate names with a comma.