Success := false; Well I installed the bar today at the install day and it clunked majorly. Right now I am driving with the bar...
I know where to get an eg33.
I'll bring mine but I hope your not planning on doing a clutch tomorrow.
Your engine doesn't look anything like that. It is spread out all over the floor :rofl:
you have to get an alignment after putting coilovers on?
I have ASIC's Gel 1120 launch control. It doesn't do much in terms of building heat in the manifold. :) Aren't you at Roebling?
This thread actually has a topic? FWIW I ran a XX-Tuning header for a while. I believe it was a GT Spec clone. Either way it worked well...
you coming to the install day?
what version access port is it? If its version 1 you can use the open ecu tools to tweek the injector scaling
On second though I say screw the 18g and go real big... The small turbo on the left is a 20g. The slightly bigger turbo is the t3/to4s [IMG]
Now if you plan on doing a 2.5 swap you might as well get the 20g. The 18g will be on the small side for a hybrid.
both the 20g and 18g come in td05 and td06 flavors. I am not saying get a 20g. For the 2.0l a the 18g would be as big as I would go. Check...
No way in hell you can get 400whp from that turbo. The td05 will spool *slightly* better on a 2.0 but I wouldn't want to give up the topend of the...
Are we going to be installing a turbo Sunday? :naughty: Is it a tdo5 or tdo6 ?
I never ran a 2.5 na block. I just had one laying around. The heads are Version 6 with oversized valves and a port job with version 5 sti-ra cams.
Here is my post from when I ported them. http://forums.nasioc.com/forums/showthread.php?t=883952 I am trying to dig up the charts that are...
Yep. My pump is leaking. I sent it out yesterday to get it fixed. Not sure if I am going to put it back in or sell it. I have an ecutek ecu...
Open source. I was getting pretty close with my tune but then I ran into meth issues. Not sure what I am going to do now.
If you do it yourself the total cost is less than 20 dollars in gaskets. It took me about 6 hours to do mine. About two hours removing and...
We did that. Once it got to 4 volts it flaked out. Still wanted to make sure before spending 240 on a new one.
Separate names with a comma.